[PDF]Aprilia Scarabeo 4T servicemanual - Scootergrisen
scootergrisen.dk/scooterhjemmeside/.../aprilia_scarabeo_servicemanual.p...
Release 00. 2003-02. 1. Scarabeo 50 I.E.-50/100 4T. FOREWORD. – This manual contains information covering normal serv- icing procedures.
NOTE The bearings must rotate freely, without halting
or noise otherwise they must be replaced.
– Use only original aprilia SPARE PARTS.
– Use the recommended lubricants.
– Always lubricate parts before reassembly.
– When tightening screws, nuts, and bolts, start with the
largest diameter fasteners. When several fasteners are
arranged in a pattern, start with the innermost fasteners, and tighten diagonally across the pattern.
Tighten each fastener successively before applying the
final tightening torque.
– Always replace gaskets, grommets, circlips, O-rings
and split pins (cotter pins) with new ones.
Before assembling, clean all mating surfaces carefully,
removing all traces of the old gasket and gasket
sealing compound. Also carefully clean any oil seal you
plan to reuse. It is recommended that all oil seals be
replaced each time they are disassembled. Gaskets
should never be reused.
Apply a thin film of lithium based grease to all oil seals
before assembling.
Install oil seals and bearings with the identification
mark or serial number facing outward (visible). Copiously lubricate bearings before installation and be-fore
assembly.
– Make sure that each component has been reassembled correctly.
– After any repair or periodic maintenance operation is
carried out, the vehicle must be test ridden in an area
away from traffic and other hazards.
You can Download Aprilia Scarabeo 4T Service Manual Below
If the information you are looking for less, you can use the sponsored links to get related information
Get the file Download Here
Tidak ada komentar:
Posting Komentar